Guest jaylift Posted November 13, 2006 Share Posted November 13, 2006 Can any of you direct me to the engine out procedures for a cessna 172-P ??? Link to comment Share on other sites More sharing options...
brabus Posted November 13, 2006 Share Posted November 13, 2006 Look in the POH, ask your instructor. Link to comment Share on other sites More sharing options...
Buddy Spike Posted November 13, 2006 Share Posted November 13, 2006 Maintain aircraft control. Analyze the situation. Try to restart the engine. Land in a field. Link to comment Share on other sites More sharing options...
Ram Posted November 13, 2006 Share Posted November 13, 2006 I was going to post something really funny, but I didn't want to "ruin BaseOps" by being hilarious. Dude...you might want to try GOOGLE or something. Or actually read the POH. Either way, this thread is GOING PLACES! 1 Link to comment Share on other sites More sharing options...
Ram Posted November 13, 2006 Share Posted November 13, 2006 Ok, because I was bored, I went to Google myself. Searched "Engine Failure Cessna 172," clicked "I Feel Lucky," and BOOM: https://www.usau.com/USAU.nsf/Doc/Cessna172...sna_skyhawk.pdf Page 11, #27: "Engine failure procedure: Establish 65 KIAS glide, avoid obstacles, flaps as required. Refer to POH, Section 3,Engine Failure Immediately After Takeoff, and Amplified Procedures." Total search time: 2 minutes. Link to comment Share on other sites More sharing options...
brabus Posted November 13, 2006 Share Posted November 13, 2006 Avoid obstacles...damn it, I knew I always forgot a step! 1 Link to comment Share on other sites More sharing options...
FUSEPLUG Posted November 13, 2006 Share Posted November 13, 2006 ABCs of an engine failure. Airspeed - Best glide Best place to land Checklist - There are different techniques out there that people use for a restart attempt and then for securing the engine before touchdown. In the Cessnas I always taught the inverted L as a logical flow for making sure everything was set up properly for an attmepted restart. Fuel Selector on Throttle just out of idle Mixture full rich Carb heat on (if not fuel injected) Mags on both Master switch on Engage starter if its not windmilling Securing of the engine before touch down is just shutting everything off in reverse order. Of course nothing replaces actual use of the POH checklist, so take it for what it's worth. Link to comment Share on other sites More sharing options...
brabus Posted November 13, 2006 Share Posted November 13, 2006 I use(d) the same process as fuse. Pretty standard one...nonetheless, read the POH for guidance, it's good to use that and not 100% rely on what we say. Link to comment Share on other sites More sharing options...
Right Seat Driver Posted November 13, 2006 Share Posted November 13, 2006 Glide (Best Glide Speed) Grass (Where to put it down) Gas (Try to restart and/or secure) Like it was said, many different techniques, pretty much the same principles apply but be sure to check the POH and talk with your instructor. Link to comment Share on other sites More sharing options...
HerkDerka Posted November 14, 2006 Share Posted November 14, 2006 Engine - Attempt restart If restart successful, continue with checklist. Best glide - Establish 30 KTS above power off stall Pants - Shit Plane - Crash into New York apartment high rise Ditching checklist - Complete HD Link to comment Share on other sites More sharing options...
jcj Posted November 14, 2006 Share Posted November 14, 2006 Originally posted by FUSEPLUG: ABCs of an engine failure. Airspeed - Best glide Best place to land Checklist - There are different techniques out there that people use for a restart attempt and then for securing the engine before touchdown. In the Cessnas I always taught the inverted L as a logical flow for making sure everything was set up properly for an attmepted restart. Fuel Selector on Throttle just out of idle Mixture full rich Carb heat on (if not fuel injected) Mags on both Master switch on Engage starter if its not windmilling Securing of the engine before touch down is just shutting everything off in reverse order. Of course nothing replaces actual use of the POH checklist, so take it for what it's worth. 172P will have carb heat. Get carb heat on without delay because if there is carb ice, you may still have some hot air to try to clear it. The hot air will go away quickly if the engine is stopped. I was taught to immediately pull carb heat on as you are going to best glide and looking for a landing field. The rest of the checklist can wait until airspeed is established and landing field identified. I like the "L" check above, except I would add more throttle than just past idle. If no restart, you will probably walk away from it if you just maintain aircraft control and land it on the best terrain available. If you can remember, try to open the cabin doors before a forced landing. Won't affect the aerodynamics at all, but will keep the doors from being jammed shut (trapping you inside) if the fuselage is warped in the crash. If at night, turn on landing light just before landing. If you don't like what you see, turn light back off. [ 13. November 2006, 22:43: Message edited by: jcj ] Link to comment Share on other sites More sharing options...
Guest CrashCB18 Posted November 14, 2006 Share Posted November 14, 2006 This thread reminded me of something I was curious about when I got my PPL in a Cessna. This was the pilots' preferences on what kind of field to land the aircraft. I imagine this is different from your T-6's and T-37's because of the stall speed, glide speed, less weight of the cessna. I was always taught to find a nice flat grassy green patch of land (obviously not cornfields, just grass). Then one instructor said he preferred a brown piece of earth before crops grew because he could distinguish the direction the land was tilled and the aircraft wouldn't cartwheel going against the grain. With grassy earth, you can't distinguish that and could unfortunately go against the rows of mounds. Opinions? What about picking the best spot for a T-6/T-37? Link to comment Share on other sites More sharing options...
Buddy Spike Posted November 14, 2006 Share Posted November 14, 2006 Originally posted by CrashCB18: Opinions? What about picking the best spot for a T-6/T-37? EJECTION HANDLE - PULL(BOTH) Controlled ejection is 2000' AGL. If you can't find a suitable landing surface (i.e. - runway), eject. Link to comment Share on other sites More sharing options...
jcj Posted November 14, 2006 Share Posted November 14, 2006 Originally posted by PCL Retard: EJECTION HANDLE - PULL(BOTH) Controlled ejection is 2000' AGL. If you can't find a suitable landing surface (i.e. - runway), eject. Link to comment Share on other sites More sharing options...
Right Seat Driver Posted November 14, 2006 Share Posted November 14, 2006 Yes, land with the furrows, and not with a tailwind. There was a checkpilot that used to hang around at the airport who would talk to the CFIs about what he busts people for (besides not meeting PTS) and he actually busted a student pilot for landing with a tail wind during the simulated engine failure. I read in an issue of AOPA's Flight Training a while back that you should go full nose up trim in a C-152 or C-172 for a simulated/actual engine failure to maintain best glide speed. Honestly, I was a bit skeptical, but it really works. Just be ready to push the stick forward when you apply power or if the engine does restart in the event of an actual. Link to comment Share on other sites More sharing options...
Guest comanche Posted November 14, 2006 Share Posted November 14, 2006 If it's not in the PTS he should not fail anyone. If you are above best glide speed and put full nose up trim be ready to push forward also. It's best to put it in slowly. It will work.....your airspeed maybe different then what's published but it will be close and will vary with weight. It works for all single engine Cessna's. I haven't tried it with a 310. [ 13. November 2006, 23:51: Message edited by: comanche ] Link to comment Share on other sites More sharing options...
HerkDerka Posted November 14, 2006 Share Posted November 14, 2006 Originally posted by CrashCB18: Then one instructor said he preferred a brown piece of earth before crops grew because he could distinguish the direction the land was tilled and the aircraft wouldn't cartwheel going against the grain. I disagree. Stay away from brown farm fields if you can. Brown farm fields are generally plowed and the earth is soft. In other words, if you try to land in it, you'll probably stick the nose wheel and flip the plane, a good way to turn a good emergency landing into a fatality. Regarding T-37s and T-6, eject. HD [ 14. November 2006, 03:57: Message edited by: HerkDerka ] Link to comment Share on other sites More sharing options...
Guest thefranchise Posted November 14, 2006 Share Posted November 14, 2006 never land a retractable gear airplane gear down in a field. i'm pretty sure landing on a road is prohibited in the AETC world in one of the 1,287 redundant regulation manuals. Link to comment Share on other sites More sharing options...
Guest cropdusterdave Posted November 15, 2006 Share Posted November 15, 2006 As a former cropduster and speaking from experience....go for the corn! Link to comment Share on other sites More sharing options...
Smokin Posted November 15, 2006 Share Posted November 15, 2006 Originally posted by CrashCB18: Then one instructor said he preferred a brown piece of earth before crops grew because he could distinguish the direction the land was tilled and the aircraft wouldn't cartwheel going against the grain. With grassy earth, you can't distinguish that and could unfortunately go against the rows of mounds.Sounds like your instructor had never been to a farm before. If there's grass on a large field that means the owner has either a) not tilled in a long time (if ever), thus no/small rows to worry about or B) growing grass for hay, again no rows. Corn has very tough stocks that would slow you down faster than grass would (plus has very obvious rows), so that would probably be preferable so you don't hit that tree at the end of the field. Everyone talks about the fields, but what about the farm roads surrounding all the fields? Link to comment Share on other sites More sharing options...
Guest kpaul Posted November 16, 2006 Share Posted November 16, 2006 If you are in a dry climate hay fields will have irrigation ditches that you may or may not be able to see if the hay has not been cut. I went on a accident investigation with the FAA in which a dumb a$$ doctor ran his C-182 out of fuel landed in a field. He was able to get the farmer to drive him to the airport to get fuel. After putting 5 gals in each wing he was ready to take off. The farmer told the doctor to take off in a Westerly direction. The doctor being the steller pilot he thought he was ignored the farmer and started his take off roll to the north into the pervaling wind. He made about 40 kts before impacting a 3 foot wide X 2 foot deep ditch. The plane ended up on its top. The Dr was able to walk away but the plane was a total loss. Link to comment Share on other sites More sharing options...
FUSEPLUG Posted November 16, 2006 Share Posted November 16, 2006 Originally posted by Five-Oh Co-Pilot: I went on a accident investigation with the FAA in which a dumb a$$ doctor ran his ________ out of fuel landed in a field. Fill in the blank (usually a Bonanza) and that's how most GA accident investigation stories begin... Link to comment Share on other sites More sharing options...
Ram Posted November 16, 2006 Share Posted November 16, 2006 Originally posted by FUSEPLUG: Fill in the blank (usually a Bonanza) and that's how most GA accident investigation stories begin... Link to comment Share on other sites More sharing options...
desmond kelly Posted June 16, 2017 Share Posted June 16, 2017 With regards to attempting a restart.I remember an instructor saying once that the chances of the engine starting up again are something like one in a hundred.Does anyone know if this is reasonably accurate assumeing of course that the prob.is not carb.ice?? Link to comment Share on other sites More sharing options...
FUSEPLUG Posted June 17, 2017 Share Posted June 17, 2017 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now